I am willing to make a couple of Mk1 docks in a similar style.

But the problem is that I don't have a Mk1 to measure and test fit with.

For this to happen, somebody who owns one (Laura?) will have to first acquire the docking connectors (there's a thread somewhere on where to get them from, and a note in the FAQ, I believe). With those in hand, the Mk1 owner could make some detailed measurements for me (I'll specify what I need), and then send the measurements and the connectors to me.

The types of measurements are the usual side-to-side and front-to-back dimensions of the Mk1, plus front-to-dockingconnector measurements, and locations of any protruding screw heads from the Mk1. The Mk2(a) units have four screw heads on each side of the unit that protrude significantly enough that the currrent design had to incorporate machined channels in the MDF to allow them to slide in/out without scraping.

First step.. get a couple of Mk1 docking connectors and then contact me again.

Cheers