Hi there,
I want to remap the tel mute signal to switch it to the aux in...so that the sound come throught the speakers. I know that you can do it in hijack, I just cant find the thread that said how. Can anyone remember how to do it?
Anyway, I think I might have just broken a record for the bbs. I've been a member and regular viewer from it's inception and this is my first post!
Thanks in advance

[hijack]
extmute_on=button
extmute_off=button

Mark beat me to it. Funny though. That's actually your 9th post, but your first one was also about phone mute, 4 years ago! =]

Heh, but 4 years ago, I don't think Hijack existed, or at least it didn't have that feature.

Hey, thanks for the prompt replies. Goes to show what my memory is like! I'll give it a go when I get home.
Loren, I've now got my empeg in the Scooby but the installers cocked it up, so I'm getting another fascia surround and going to re-do it

Another facia surround ? ? Those are like 80 bucks! I hope you didn't have to pay for it!

I have friends in important places...i.e. his Father owns the local Subaru dealership, so 'm hoping it won't be too bad.

Hello

I have two questions I hope you can answer; 1/ does the telephone mute require enabling as mine is not responding to a GND? and 2/ can the output of the mp3 audio be attenuated instead of muted?

Sw is v2.0 hijack (aging hijack)

Yes, I think you control whether it's enabled by using the "Configure Player" screen in Emplode.

It can be attenuated, but as far as I know you're not going to get it to mix the mp3 sound under the aux in.

Matthew

You basically gave the required info in the second post of this thread I think Mark.

Code:

---

[hijack]
extmute_on=Hush
extmute_off=Hush

---

should work I think however there is potential for it to get out of sync if the player isn't running when extmute goes active. Alternatively some kind of "Volume+, Volume+, Volume+, Volume+, Volume+" (and appropriate Volume- codes) sequence would work although it would suffer the same sync issues possibly.

As for actually getting the line to work, from memory it will default to the low/GND state i.e. applying GND won't do anything - you need to apply +12V to see anything. Have you seen this?