hda: FUJITSU MHM2200AT, ATA DISK drive
hda: FUJITSU MHM2200AT, ATA DISK drive
hda: FUJITSU MHM2200AT, ATA DISK drive
hda: FUJITSU MHM2200AT, ATA DISK drive
hda: FUJITSU MHM2200AT, ATA DISK drive
hda: FUJITSU MHM2200AT, ATA DISK drive
ide0 at 0x000-0x007,0x038 on irq 6
hda: FUJITSU MHM2200AT, 19077MB w/2048kB Cache, CHS=38760/16/63
empeg-flash driver initialized
smc chip id/revision 0x3349
smc9194.c:v0.12 03/06/96 by Erik Stahlman (erik@vt.edu)

SMC9194: SMC91C94(r:9) at 0x4008000 IRQ:7 INTF:TP MEM:6144b MAC 00:02:d7:28:0c:c
1
Partition check:
hda:hda: recal_intr: status=0x51 { DriveReady SeekComplete Error }
hda: recal_intr: error=0x04 { DriveStatusError }
hda: read_intr: status=0x59 { DriveReady SeekComplete DataRequest Error }
hda: read_intr: error=0x04 { DriveStatusError }
hda: recal_intr: status=0x51 { DriveReady SeekComplete Error }
hda: recal_intr: error=0x04 { DriveStatusError }
hda: read_intr: status=0x59 { DriveReady SeekComplete DataRequest Error }
hda: read_intr: error=0x04 { DriveStatusError }


doesnt look to good
when booted the HD spins up then goes into this thing where is sounds like it keeps trying to spin up.
then I get a pump error when I try to upgrade.

Ok so no one can help me here?

Other than the usual FAQ entry, I can't think of anything.

You may have a faulty drive cable, but with that kind of error it is difficult to tell.

Well Ive replaced the drive cable before so unless the new one you sent me is having issues then I dunno I guess Ill have to send it to you guys.